Repairing a Paslode F350S Framing Nailer

Mike attempts
Mike attempts
11,053
0
2023-09-06に共有
I got this Paslode F-350S framing nailer for free because it's not working. The sleeve was gritty feeling and then I accidentally ruined it while cleaning. The sleeve seal was cracked and brittle and the post bumper was destroyed. I replaced all O-rings, just to be on the safe side. See links below for the parts and tools I used:

O-Ring Kit & Sleeve Seal (402011):
amzn.to/44GaPvo (affiliate*)

Post Bumper (500453):
amzn.to/3Z0wrS2 (affiliate*)

Snap Ring Pliers:
amzn.to/3eHsQ5l (affiliate*)

*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
コメント (14)
  • @Mikeattempts
    O-Ring Kit & Sleeve Seal (402011): amzn.to/44GaPvo (affiliate*) Post Bumper (500453): amzn.to/3Z0wrS2 (affiliate*) Snap Ring Pliers: amzn.to/3eHsQ5l (affiliate*) *Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
  • @robertosban201
    Wow piece by piece step for step and very easy to understand
  • @dougjohn45
    Very good job Mike. Thanks for sharing. With this video I'm gonna try it. I can always refer back to your video.
  • @Mofm-tl8ov
    Lots of pitting on the aluminum (magnesium?) sleeve from water corrosion. This tells me a better water separator and a tool oiler would be advisable on the compressor. I would have enjoyed seeing an attempt to rehab the sleeve with a cylinder hone. Hard to tell how deep the pitting was.
  • @caminotorino4547
    So fixed my leak from other comments I left, now I'm not able to drive nails however. First time dealing with piston problem for me. I can drive the first nail but doesn't sink, then the next won't feed because driver doesn't retract far enough to allow clearance for next one Where should I start diagnosing this issue? Keep in mind just did full gasket/seal rebuild on the top of the gun
  • @Matt91593
    I replaced everything and o rings weren't even bad. New seal and it leaks out the side of the back cover. Only damage is the guide pin for the back cover is broken. But I don't see how that would effect anything being the seal covers it.
  • @amberkelly6643
    Video, really well done. Can u guve me an idea of cost, i just inherited one nyself. Btw. Merry x!
  • @johncampbell-lp2cl
    For a novice, what angle nails does this gun take. I can't find anywhere that is says.
  • @caminotorino4547
    Got another F350S in for repair, trigger not actuating. Basically perpetually pressed in and won't release outwards Took out retaining pin and grommet, pulled trigger out and saw there is no spring behind the trigger like at 03:28 in your video So now I went into the diagram for it to order part and notice there's not even a spring in the diagram. But I definitely have that little nipple to catch the spring just like in your video Any ideas?