Repairing a Paslode F350S Framing Nailer
11,053
Publicado 2023-09-06
O-Ring Kit & Sleeve Seal (402011):
amzn.to/44GaPvo (affiliate*)
Post Bumper (500453):
amzn.to/3Z0wrS2 (affiliate*)
Snap Ring Pliers:
amzn.to/3eHsQ5l (affiliate*)
*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
Todos los comentarios (14)
-
O-Ring Kit & Sleeve Seal (402011): amzn.to/44GaPvo (affiliate*) Post Bumper (500453): amzn.to/3Z0wrS2 (affiliate*) Snap Ring Pliers: amzn.to/3eHsQ5l (affiliate*) *Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
-
Mike, this is the best tutorial I have ever seen. Thanks
-
Wow piece by piece step for step and very easy to understand
-
Very good job Mike. Thanks for sharing. With this video I'm gonna try it. I can always refer back to your video.
-
Lots of pitting on the aluminum (magnesium?) sleeve from water corrosion. This tells me a better water separator and a tool oiler would be advisable on the compressor. I would have enjoyed seeing an attempt to rehab the sleeve with a cylinder hone. Hard to tell how deep the pitting was.
-
So fixed my leak from other comments I left, now I'm not able to drive nails however. First time dealing with piston problem for me. I can drive the first nail but doesn't sink, then the next won't feed because driver doesn't retract far enough to allow clearance for next one Where should I start diagnosing this issue? Keep in mind just did full gasket/seal rebuild on the top of the gun
-
great job dude!
-
It worked 😉
-
I replaced everything and o rings weren't even bad. New seal and it leaks out the side of the back cover. Only damage is the guide pin for the back cover is broken. But I don't see how that would effect anything being the seal covers it.
-
Good Desciption video...Just the facts...!! Thanks!!!
-
Video, really well done. Can u guve me an idea of cost, i just inherited one nyself. Btw. Merry x!
-
For a novice, what angle nails does this gun take. I can't find anywhere that is says.
-
Got another F350S in for repair, trigger not actuating. Basically perpetually pressed in and won't release outwards Took out retaining pin and grommet, pulled trigger out and saw there is no spring behind the trigger like at 03:28 in your video So now I went into the diagram for it to order part and notice there's not even a spring in the diagram. But I definitely have that little nipple to catch the spring just like in your video Any ideas?