Trigger valve rebuild on pneumatic framing nailer
13,818
Published 2020-05-19
All Comments (12)
-
Man o man do I wish I found your video sooner!!! Thank you so much!
-
We need a video of how to get to that piece. I can’t remove the smaller pins.
-
good video ive been replacing o rings on a hitachi nr 90 ae. trigger assembly i didint see any repair video on this gun anyway i still havent got it right
-
Very helpful, thanks
-
I have to be honest folks, I used a bit of atf as an assembly lube and my trigger quit working. BE ABSOLUTELY SURE TO USE A CORRECT AIR TOOL OIL.
-
at about 6:04 you point out one of the rings is most important. but you do not indicate which position it is. there are 3 on that piece
-
You should get head cam to show how you remove—be even more helpful.
-
Would you have a video how to remove the trigger?
-
Thanks for your video. Where the air was leak? From the front where the nails go out or by the trigger? I have replaced the orings inside but all air exit by the front where the nails go out and no leak by the trigger.
-
Hi I have a similar nail gun with air leaking where can I buy a O ring set for the trigger valve from please?
-
any chance you can reply with the eBay listing number of the trigger seal set you purchased?