How to Revive a Dead 18650 Li-ion Battery Cell After Overheat
39,886
Published 2018-08-10
All Comments (21)
-
For anyone thinking this is fake, it actually works. There is a fuse-like function just under the + cap, and they kinda swell up in case of overheating to prevent explosion. What he did was, put them back together by hammering the swollen plate down. But guys, unless you are completely broke, just buy a new battery for your own safety....
-
This is dangerous. You're bypassing a safety feature of the batrery
-
lol. i love the fact he very clearly stabbed himself in the finger hahaha
-
If you do this, good luck
-
Good, it reset the fuse
-
PSA: Don't do this! (if it wasn't already obvious)
-
When I press it with needle some type of gases realeased
-
This is very dangerous if they actually overheated
-
R.I.P.
-
Yes this works ,but man it's definitely dangerous,one wrong move it will boost into flame's 😮
-
Bad video, you show but explained nothing.Material of rhe nail, how strong to hit, depth to drill...
-
This looks super dangerous
-
Hope it don't leak too much on you after hammering the cid
-
No sir please dont
-
no no good . boom go.
-
From where I get cylindrical ferrite?
-
How much is that device?
-
what the fuck!!! you could just use a tiny flat screw and push down the side of each positive holes! no need to drill!
-
None of these videos show if its possible to revive them from the dead they always have a voltage one of mine has 0 volts 0.
-
What a load of tosh..!!