Aqua Burst X100 Thunderbolt End Gun Sprinkler

1,818

23 0

Published 2024-03-17

Here's a XCAD Aqua Burst X100 Thunderbolt part circle pivot end gun sprinkler. It has a 2" FNPT inlet, 18 degree trajectory. The sprinkler has a 0.6" (15.2mm) nozzle running at 36 PSI (2.48 bar) with a flow rate of 66 GPM (15.0 m3/h). At that pressure and nozzle size, the watering radius is 107 feet.

#irrigation #sprinkler #aquaburst

All Comments (10)

@wayneessar7489 4 months ago

I like the gentle reversing action and of course seeing it go...!
@rayhayden 2 months ago

Seriously satisfying to watch industrial size sprinklers in action! Another LIKE on your video!
@JohnCRV 4 months ago

Another great demo Sir! Thanks for sharing. 👍
@antiquesprinklers 3 months ago

You photograph these things so beautifully. Impressive sprinkler. I was really surprised by the relatively low pressure reading. I was expecting to see it up around 80 PSI.
@beebeesfuntasticadventures6110 4 months ago

Sprinkler looks efficient and covers a large area.
@Shimizoo32 3 months ago

It's a very good product🌲🚿👍✨
@NelsonBigGunP200Fan 4 months ago

Did you know there are 3rd party mods for the Nelson guns ? It's like a deflector that rides along an adjustable track. And you can set it to shorten the distance at certain points like a Gilmour pattern master. So like if it got near a road it'd shorten the distance down so it just gets the crop then when it's past that the deflector comes out and it has full distance again. It runs great on this setup. .60 is a good nozzle for lower volumes. Gives you more pressure.
@NelsonBigGunP200Fan 4 months ago

I would like to get one of these someday. I heard they're like a SR75/100
@gennaromonda8211 4 months ago

Buonasera dove lo potrei aquistare ? Questo irrigatore ? Signore ?