How to check/change/replace wheel bearings on Polaris RZR | Maintenance Matters | SuperATV
113,189
Published 2019-07-15
Get your replacement bearings today:
www.superatv.com/search?q=wheel%20bearings
Check out our full line of products:
www.superatv.com/
#SuperATV #MaintenanceMatters #UTVMaintenance
00:00 Intro
00:13 Check Your Wheel Bearings
00:26 Remove the Wheel
00:42 Remove the Factory Components
01:39 Remove the Ball Joint from the Upper A-Arm
02:12 Place the Spindle in the Press
03:54 Reinstall the Bearings
All Comments (21)
-
Nice video only suggestion would be to show or provide tips on how to remove the bearings without a press and how to insert them. The answer? You can use a torch to heat the outside of the hub housing. This will expand the hub bearing diameter just a tab and make it much easier to hammer out with a brass punch or properly sized punch. Then you can place your new bearings in the freezer overnight and they will basically drop into place. Freezing them shrinks them ever so slightly.
-
This (and she) is fantastic. Thanks for the content. Wheel bearing replacement in my future. Appreciate the video.
-
A hottie at my fav part supplier.
-
Most of these people know less than you so keep it up!
-
my hub must be glued on there, aint slidding off thats for sure
-
Kristen, that winking session at 1:39 is very flirty....lol Joking, good video!
-
Mine has never come apart that easy...lol
-
I really like that know one pointed out….the importance of make sure that the caliber is hanging from its hose😆
-
You should specify the year because on my 2017 the snap ring is on the inside and the bearing comes out and goes in the exact opposite of your video.
-
what size socket is needed to remove the axle nuts front and rear on a 2018 rzr xp 4 1000?
-
what size are the correct adapters?
-
I wouldn't be working in with ring on lol
-
on the instructions, it says to apply Loctite 603 retaining compound to the outside surface. Is that mandatory or not?
-
Overall labor hrs for rear?
-
Wowwwww😍😍🙏🙏
-
Just wish there were torque specs for reassembly. Otherwise, good video.
-
What mechanic wears a 4K diamond while working?
-
And of course my race came off on hub
-
Wait a minute!! What was she working on!!!!!!?😁👀
-
Great video but she forgot to grease it