10 Fabrication Tips in 10 Minutes!!
219,327
Publicado 2021-03-31
10 quick welding and metal fabrication tips in 10 minutes.
Please checkout this videos sponsor, Empire Abrasives: bit.ly/2RbhA5h
Use promo code "VOSS" for 10% off your first purchase.
Defiant Metal Welding Gloves: defiantmetal.com/store
Socials:
Instagram @JustVoss: www.instagram.com/justvoss
TikTok @JustVoss: www.tiktok.com/@justvoss
Twitch: twitch.tv/justvoss
(Amazon Associate Links)
My Amazon shop with more of my favorite products: www.amazon.com/shop/justinvoss
Join the channel to get access to perks:
youtube.com/justinvoss/join
Todos los comentarios (21)
-
The first tip alone was worth the whole 10 minutes!! Thank you!!!
-
Great tips Justin, thank you!
-
I always enjoy learning new methods of dealing with common problems in the shop. Hopefully these "10 tips in 10 minutes" is a reoccurring series on J.V. channel. I enjoy the content and well thought out delivery. Subscribed!
-
Super job Justin!!!! Been in fab/weld for 30 years. You just taught me a few new tricks..
-
Drawing the perfect circle is easy, it’s cutting it where it gets difficult. Thanks 😊
-
Use the 10" mark instead of the 1" mark to eliminate end play error. This way is much less prone to forgetting to subtract the offset.
-
I’m new to fabrication, these tips were gold. Thank you!
-
#2 is a game changer for me thanks! Love the vid 🤘
-
Not bad for a "committed amateur" -- I knew 7/10! But, that first tip was fire. So smart. Enjoying your channel quite a bit, keep up the good work.
-
I just started Frazier Industrial as a fabricator. First time reading a blueprint on a test yesterday. I hope I do good on the job.
-
Thanks for the tips Justin. I know these videos take time to make/edit, so thanks for taking the time. I actually found some of them useful and will be using them.
-
Thanks for the video bro. Helpful content
-
Would love to see a video of you talking through all the discs you use and why you use them. Thanks for the great content!
-
Really awesome tips thank you.
-
Man, i loved this. I used to work as a blacksmith and I wish I knew these tricks then. Also, after watching this I realize I should look into sheet metal and fabrication apprenticeships. I love metal.
-
A decent enlightening post that you have shared and appreciate your work for sharing the data. I value your endeavors and all the best. Praise your work and continue sharing your data.
-
Thank you for these tips. First one would be my bet. Keep your video coming!
-
Never knew about the center of a circle one. Amazing. Succinct video. Beautifully done.
-
The countersunk bolt head for weld nut is awesome
-
Great video. There's actually a very specific reason why every single tape measure has that play at the end of the tape, it is to compensate precisely 1mm where you're hooked on the a peice or when pushing against it. But I guess it can where out over a long time.
