Repairing a Paslode Stapler

2,189

87 0

Published 2024-01-10

I got these two Paslode 3150/38 W16R wide crown staple guns for free because they have broken and missing parts. The good news is, between the two, I think I can make a functioning stapler. Parts and procedure should be the same for the Paslode 3200 staplers. See links below for the parts and tools I used:

O-Ring Kit & Sleeve Seal (402725):
amzn.to/3TYY11o (affiliate*)

Bumper (403855):
www.ebay.com/itm/165868645235

Sleeve Flange (405243, if you need one):
amzn.to/41PwMbA (affiliate*)

Snap Ring Pliers:
amzn.to/3eHsQ5l (affiliate*)

*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!

All Comments (5)

@Mikeattempts 6 months ago

O-Ring Kit & Sleeve Seal (402725): amzn.to/3TYY11o (affiliate*) Bumper (403855): www.ebay.com/itm/165868645235 Sleeve Flange (405243, if you need one): amzn.to/41PwMbA (affiliate*) Snap Ring Pliers: amzn.to/3eHsQ5l (affiliate*) *Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
@Grainraiser 2 months ago

I have this same stapler I purchased off EBay 15 years ago for $12. Your video has given me the confidence to repair it. Thank you sir.
@Eeevihy 1 month ago

Great videos you have. Sometimes the problem can be with the staples. Once we had a batch of faulty staples and staplers were jamming all the time. After checking through every stapler and their parts there were no problems with them. The conclusion was that the staples had just a little bit too much glue between the staples and it was just enough jam the stapler once for a while.
@weetbix1000 1 month ago

Need to redo the rings also. Great video by the way