Minelab Equinox 900 - How-to Remove an Unwanted Target - Simple and Easy!

In all the time I have owned the 900, how did I not know this. I have numerous sites where this will come in handy. Awesome tip!

I have not notched anything out in a long time except Iron on my 700 But always good to know that you can on the fly as yes there is a lot of unwanted targets.. Thanks for Sharing . Peace

Good info. Didn't know I could push the button while scanning the target. Thanks!

Thanks this will be really handy.

Nice. I would like to see a similar vid for the FE. It's supposed to be able to knock out small iron but I can't see any difference. If you did an air test with a square nail or small bit of iron using a low FE vs. a high FE....I'de love to see/hear it work. Some people say FE will lose small rings if set too high....again, I'm surprised there aren't more vids out there about FE since it seems like a valuable setting if used right. Thanks!

I have been hunting in 15 kHz on the 900 for about 3 months from a Chanel i found will post her Chanel have forgotten the name but have found lots of gold jewelry now without notching out anything pull tabs near the surface do ring up very clear but far and few digs on them

Great video.. I will, however, add that when you are in the Acc/Rej menu, you can set discrimination patterns easily with fewer button presses.. Whenever you push the reject or accept button down on a target ID at the beginning of a range you'd like to notch out, just continue to hold the button down and hit the +/- button to apply the A/R automatically as you scroll through the range. Thanks, and keep your coil to the soil and your digger in the dirt

Nice job as usual.... Love my Nox 900! Your card placement needs to be a little longer at the end of your video : )

Great video.Have you got anything on the M9 coil yet?

Superb hack , cheers matey

I would do that with my Nox 600 when I couldn’t bare digging up the same old trash a particular spot. I normally keep it in all metals and sometimes in the non ferrous mode. Now that I have the Nox 700, I will experiment with it, since it’s got more VDI segments. Great tips for those who are trying to get familiar with the Equinox models. _/ 👍🏻 (If you saved the trash you just notched out, you can scan back over it or swing it across your coil and add it back in, by pressing the + when it’s VDI number is on the screen.)

Wow Awesome info as always. Thanks Have you done a comparison between the 900 and the Manticore VDI numbers. Are they the same on like targets?

Now the manticore please👍

What about advanced settings to notch.

So ya could even add same program to 900 when ya think about it outa 50 rings tested have 7 types covered just in case a ring is in area when coin shooting so could class program as a mirror image of all metal but still in notch form for hunting .

Not sure , but didn't the 800 have this also ? Thanks

If you knock out the pull tab will it hit a different signal underneath it as i will try and test that the next few days

Yer heaps cracked up about xterra as well stabilised with advanced settings more to nox than meets the eye on the xterra program I knocked out 8.. 9 but notch under load it comes in ie a ring but program is set for coins. So good thing is hunt for coins ect but if a ring is in sweep path boom ya have it but that is on single frequency not multi.

This is for xterra pro users unit is dead silent even in doors not a click vdi rock solid have not tried on 800 yet in advance xterra is one of a kind here is program on 900 but one will have to do extra in target tone advanced.

Which do you like more manticore or 900