LM-UTV 72" X3 High Clearance Radius Rod Install
12,614
Published 2019-10-24
All Comments (13)
-
Just got me a set for Black Friday and really appreciate this video!
-
The rc version sopose to be thicker then the other also so if you bent yours the other models must bend really easy
-
I realize this is an old video so hope your still active. Are you able to adjust the camber and toe with the wheels and tires on? I know on round radius rods, you turn the rod and then once properly aligned you lock everything down. With these being rectangular shaped, you would have to take them off and turn the heims in full revolutions correct? Sorry if dumb question, I've jacked my rear end up to where driver side rear is toed in several degrees and have diagnosed it to be rods and pull plate, so deciding on what route I want to go. Thanks for any info and great video!
-
Wish you guys showed installing the lower one
-
Nice work buddy. How are they holding up?
-
Did you realize on bearing side one half has a fat oring and the other a skinny oring..does the fat oring go towards the machine or to the outside..(just realized there is no left and right with respect to orings..one side has fat oring on the inside, other side fat oring on outside)
-
How do you lock your heims in place
-
Do you have to take off the tire to remove and reinstall the bottom radius bar . Thanks
-
What year model is this? And has it been changed or up graded on the 2020?
-
Have you had an issue with these rubbing on the frame?
-
How are the radius rods holding up?
-
Should I get my x3 aligned somewhere or would I be fine riding on it before I take it in somewhere?