How to drill a 3/4 or 1/2 inch hole in thick stainless steel sink using cheap basic tools
4,267
Published 2020-06-15
All Comments (5)
-
You need to explain this better..... You Do Not want to get the steel too hot. So you need to take your time and go in short bursts. If you overheat the steel you will never get a hole in it because you are actually hardening it. This type of sink in particular Kraus I think.... The bowl is 16 gauge but the deck is 3-4 mm thick. WD-40 maybe not the best choice. Maybe 3 in 1 oil.
-
Thread cutting oil would serve you better than wd40. That's something I've learned the hard way. Did that wreck your hole saw?
-
i saw people use dishwashing soap as a lubricant. Do you think that would be better?
-
That is NOT "speed" 2 Farad.
