Rhino Tutorial | Industrial Design | Vacuum Sealer Part 1
4,790
Published 2022-12-01
drive.google.com/file/d/1u_6kdSX5yaeedcjhzE8mmeL1N…
Reference tutorial:
www.bilibili.com/video/BV1Mv4y1c7pi/?spm_id_from=3…
Product:
www.waringcommercialproducts.com/p/13er1/handheld-…
Model_1:
drive.google.com/file/d/1vhmTP0Ylcu-vKK_UDPk0cQE_x…
All Comments (7)
-
Best explanation EVER!
-
Thank you!
-
Thanks for the tutorial vid, Daoru. but I couldn't get how you managed to pull down the two curves at the back while also pulling down the curves reflected on the surface. really appreciate it if you could enlighten on that. 12:50
-
Hi, what's your approach to modeling more complex objects, whose cross-sections vary more than in the vacuum stealer in the tutorial? Would starting with surface network, sweep1, or sweep2 but with more cross-sections have bad implications for further steps? PS: thanks for the valuable tutorial :)
-
Hi Daoru! Thanks for your wonderful tutorial, as I see in some of the comments below, I am also getting too many checkpoints and too many slashes on the surface, when I do "Sweep2"... (video 6:08 ) I checked if both curves have the same angles and points, and they do, so I'm not sure what I'm doing it wrong..
-
In Sweep2 there are too many checkpoints and too many slashes on the surface.