FX Impact Regulator (AMP) regulator creep fix.
Published 2022-02-06
I have fixed and resolved many AMP regulator issues including the commonly know reg creep.
Watch and learn how I do it to achieve best possible results.
Get you 3m polishing papers from here ⬇️⬇️
www.stewmac.com/luthier-tools-and-supplies/supplie…
All Comments (21)
-
Thank you Steve appreciate all you do for the community.
-
Brilliant work, great tutorial 👏. I love the idea of how to up the reg pressure by taking a dry shot and quickly give a small turn so they’re not touching yet 😉👍👏
-
Very informative and clear. Many thanks 🙏👍
-
great vid Steve. A little effort always pays a massive reward. I get reg creep if I fill too quick. She will get the SB treatment next time shes in bits. 🤣
-
Awesome. Worked perfectly. Thank you.
-
Thanks for sharing, great info. Keep it coming :)
-
Perfect video mate thanks a lot 🤜🏻🤛🏻
-
Great video thanks.
-
lol good idea of dry firing and then increasing the reg pressure . i do the exact same procedure but my reason was that there is less pressure in the plenum hence leading to less strain on the surfaces.(same idea though)
-
Outstanding video, nice detail, quality at its Best! Great advice as well on it’s just not a good idea to adjust any airgun under such high pressure and brilliant on the quick adjust immediately after firing! Thanks buddy!
-
Nice vid mate thanks 🙏🏼
-
Nice video spot on.
-
Great Video, did it some time ago, and never ever had creep againg, reg set @ 160 bar
-
Thanks a lot ❤
-
Brilliant Video, it's answered a lot of questions about Reg creep on my sub 12 Maverick, i have wondered about fitting the adjuster screw with new O'Rings fitted going through the threads of the Reg body causing damage to the O'Rings, i have 11 washers in my Maverick Reg, 6x 0.5 4x 0.4 and 1x 0.5 is there any particular order in size they should go on the shaft.
-
I just rebuilt my old Crown reg. Those small 2X1 mm O-rings are difficult to work with; it definitely requires patience.
-
By the way thanks for the video.
-
Good afternoon, I clean the same as yours, but this is for what fine brass sandpaper to sand, do you want flat or slightly conical?
-
Great vid, I see some vids they grease up them belvil washers, Surly polishing is better than covering them with silicone grease.
-
Hi ,like how you adjust the reg screw (firing a shot off) so No damage to the reg /piston ,this must work for Decreasing reg pressure (turning screw clockwise) ? Be good to know your thoughts on that !