My Hemi Tick is GONE - 2022 Ram 1500 Purrs Like a Kitten Now!

346,764
0
Published 2022-11-17

All Comments (21)
  • @4-LOW
    2012 owners manual: "NOTE: Vehicles equipped with a 5.7L engine must use SAE 5W-20 oil. Failure to do so may result in improper operation of the Multi-Displacement System (MDS)." 2014 owners manual: "NOTE: MOPAR® SAE 5W-30 engine oil approved to Chrysler Material Standard MS-6395 may be used when SAE 5W-20 engine oil meeting MS-6395 is not available" 2016 owners manual: "MOPAR SAE 5W-20 engine oil approved to FCA Material Standard MS-6395 such as Pennzoil, Shell Helix or equivalent is recommended for all operating temperatures." 2022 owners manual: "We recommend using Mopar® SAE 0W-20 Full Synthetic Engine Oil which meets the requirements of the manufacturer Material Standard MS-6395. Equivalent full synthetic SAE 0W-20 engine oil can be used but must have the API Starburst trademark NOTE: Hemi engines (5.7L) at times can tick right after startup and then quiet down after approximately 30 seconds. This is normal and will not harm the engine. This characteristic can be caused by short drive cycles. For example, if the vehicle is started then shut off after driving a short distance. Upon restarting, you may experience a ticking sound. Other causes could be if the vehicle is unused for an extended period of time, incorrect oil, extended oil changes or extended idling. If the engine continues to tick or if the Malfunction Indicator Light (MIL) comes on, see the nearest authorized dealer." So with the EXACT SAME engine with MDS, we went from "you MUST use 20 weight oil" to "it's OK to use 30 weight" to "we recommend even thinner 0W20 weight" and then finally they admitted that the watery 20 weight oils cause ticking because the viscosity is too thin and the lifters bleed down too fast, plus there is improper lubrication.
  • @CDNGoMangoSRT
    Took your advice, 5w-30 full synthetic. Engine runs smooth and quiet, no tick even after sitting for a week on cold start. This is great 👍
  • @rudigarcia1111
    Thank you for this video bud! This worked like a charm! No more ticking sound and the engine sounds great!!
  • @essasarkhy
    Thanks a Lot man, I had a tick noise in my 2014 Hemi dodge ram so I fond your video and I change the oil to 5w30 and the Hemi tick is GONE ! .... Respect from Saudi Ariba.
  • Thank you. You just answered 3 questions I have been seeking the answers for awhile.
  • Thank You Sir, very mucn!! I"m picking up my 2019 ram 1500 at a dealership here in Canada on Fri. And it definitley has then ticking sound. Thanks
  • @tgamble1000
    Should have fired-up the engine while recording so the audience could hear it for themselves.
  • @dadgarage7966
    Great upload! Good to know about the 5W30 patch work fix for these engines.
  • @dan04r1
    I own a 2021 and it feels like it’s a ticking time bomb sometimes. Thanks for the video! I will be switching over to synthetic from now on.
  • @martinhenri9432
    you might have a good point ,i never had a thick on my engine but since i went to the last oil change i now have one . thanks for the tip i will look that over ..
  • @raywagner8016
    I'm not sure if it has made a difference or not but I've always added 1 liter of diesel spec oil for all my gas engines at oil change and haven't had any issues. And a lifter from an '04 Hemi will fit and work in an '09 and later Eagle Hemi. So no, they weren't specifically designed for the zero weight oil.
  • @philip4193
    Experienced the exact same thing when I bought my Jeep JK Wrangler new off the lot back in '08. The old-school Chrysler 3.8L pushrod V6 in it was designed back in the 80's and originally ran on 15W30 oil, however by the time in ended up in my Jeep, Chrysler had changed the oil spec to 5W20 in order to meet the government-mandated CAFE targets since slightly better mileage was achieved with the thinner oil. From day one that engine was noisy with rattles, tics and knocks and always felt harsh with notable drivetrain vibrations under load and higher RPMs, and it also burned oil from new (plug fouling was also an issue); these engines in the early JK Jeeps were notorious for these characteristics until they were replaced with the new clean sheet designed 3.6L Pentastar V6 in 2011. Anyway, I started doing my own oil changes on it after a few initial dealer services and switched to a quality 10W40 oil, as I live in a hot climate and just wasn't confident that the thin oil was protecting my engine in the summer (which is why I went for a 40 instead of a 30 weight, as our summer days are often 38C/100F plus). On the first drain I did of the 5W20 myself there was noticeable glitter in the used oil, and it seemed very thin and watery draining out and was jet black. As soon as I started the engine up again on the fresh 10W40 the difference was immediately noticeable; the engine idled quietly without any of the usual tics, knocks & rattles, and when I drove it and gave it some RPMs under load the engine revved freely and was silky smooth and quiet, without any of the harshness and vibration from before. On the next drain there was far less glitter in the used oil, with none whatsoever from then on; 14 years and 130K miles later and the Jeep is still running strong with no engine issues. I suspect that Chrysler's attitude regarding using this super-thin oil in order to achieve their CAFE targets is that as long as the engines make it through the warranty period then all is good, even if the life expectancy for the engine is reduced significantly; what happens after warranty's up just isn't their problem.
  • @alexecheverria8428
    I believe starting the engine would have been very positive and serve as further proof of the engine running better,thank you for the video.
  • Im an avid follower and thank you for the good videos and the time you take to do them God bless
  • I have a 2019 RAM 4x4 and I typically use 5w-20 in the winter and 5w-30 in the summer of full synthetic. Another thing that I found that really helps stop the ticking as much in the beginning is a oil additive (metal penetrant) on top to reduce the wear significantly. From doing research many mechanics have said it is because the oil pressure doesn't allow to reach the top end of the engine, hence the 6.2 hemi engine performance oil pump is the way to go on a 5.7 hemi as it bolts right up and gives more performance volume to get that oil faster on the top end! Yes, the type of oil makes a significant difference as well, no doubt! The hemi engines of today also have problems with heat/thaw on the manifolds to snap bolts, which is very common and recommendations are to change the manifolds out to shorty sport tuned headers. Stainless steel headers heat/thaw at rates closer to the aluminum heads than cast iron! There is a big difference between a good quality header and the cheap ones that are out on the market! The recommendations are to have quality tuned shorty headers from what I have heard from many different mechanics! My wish is for people to take care of what they have and may it last for many years to come! I have not had very many problems with my truck since buying it and am thankful to all the engineers who worked hard with making a quality product as I hear stories out there on many different automakers of what can go wrong and/or will eventually! I changed to quality LED backup lights on my truck also, the cheap ones had resister problems and the new ones seem to by pass those problems that even extend to the key fobs with starting issues. Buy quality when you can, then they should last and perform correctly, lessons learned! Life is an adventure!... Love you brother!
  • I run the 5w 20 full synthetic but I also run the Lucas oil additive new car formula and engine tik is gone. I have over 60K on my 2019 fifth gen with no issues and been running Lucas additive since 20K. The 5W 30 is absolutely fine but the Lucas additive is thick and does the same thing basically. Good video brother and happy motoring!
  • Excellent advice…just basic common sense! Thanks for sharing your thoughts!
  • @153eddy
    I agree 100% with this from my own experience. Bought my Ram and noticed the ticking symphony at start up. I then switched to Amsoil 5W-30 and Wix filter. The ticking symphony quit and went away immediately. Just run 5W-30 and a filter that flows well.
  • @PhatboyHD88
    My cousin has a jeep with the hemi in it , it also has the hemi tic , i just sent him this video. Thanks for the advice👍