Pool Tip: Improving Intex Pool Circulation

gave me an idea about my rectangle. Swapped the pump to my old sand filter. Now, my old rectangle was 16x36 and circulation ...sucked. I added a second port at the far end. Will add a second line to go to far end but thinking to use that fitting vice the standard jet port. I will have to try both and see what works best. Thinking to make adjustable so higher up for circulation near the top of lower into pool for bottom circulation. Loven when I had a round because debris would all end up dead center, easy to clean. Rectangles and long curved end ones wont do that.

I’ve always felt having the water go in a circular motion would also cause dirt and stuff on the bottom to go to the middle of the pool so I been manually moving my nozzle ever so often.

On the DRIMMEL which one, what attachment, you Never said. So how do We figure that out....Any video of you Doing it??

How did you remove the cap? I’m scared it will start leaking if I get forceful with it

I cannot find the video to show the circulation with the elbow on

Can you show it with the pipe installed and pump running?

you could use heat gun no dremel needed

lol.....video with no show.....

Intex pool pumps suck!