EINHELL 2112 📀 Why you only need the Cheapest Mitre Saw?

Menos mal que he encontrado este vídeo! Llevo horas intentando averiguar cómo se desbloquea la máquina. Las instrucciones no dicen nada al respecto. Gracias!

R.I.P our fallen epileptic comrades.

Thank you great video.. I’ve just bought this saw for my novice DIY projects.. I really learnt a lot.. cheers..👍

Thank you. I am just about to purchase this item and have heard that the instructions are not very good so this video is really helpful.

Thank you, this was exactly what i needed to know. Well done great video ❤

Thank you very much. now I understud 🤩

Good and detailed video. The safety button is weird, never seen it before. Seems awkward. The clamp not fitting on the right side is very common, I have the Bosch glider, and even that one doesn't fit. I never had a miter that fit. But then again, with an in-feed support table, I never use them. Get yourself a very cheap base with wheels that has the collapsible supports. If I may, your next move should be a sliding miter saw. They are a big improvement, especially on wider boards. And yes, you can use this one as your rough lumber cutter. Keep it up.

Great Video!

Good video my friend...

Nice test. Cut Max is 55 but in reality is more (before touch the carter motor). Have you the distance Max? Thx

What do you think is the maximum diameter that it can handle? It can handle 60mm but maybe even more?

Hi do beams with 40x80mm also work for cutting?

The cut the angle came out crooked because he moved the wood forward with his hand that small slide modified the cut

Taglia anche l'alluminio ?

How do you realise the saw blade from the downward position?

To be fair, 75% of the job is the blade. These cheap Mitre Saws are great or terrible based on the blade. I bought one from Amazon that made amazing claims about cutting through steel, but it shipped with a wood cutting blade. After failing to cut more than a few inches through mild steel, and going off angle, I returned the unit. Knowing now what I did not back then, I could have calibrated that saw and set it up with the right blade and cut through steel very easily. Most of the time its the blade and the knowledge. Most semi decent budget mitre saws will all do the same work in the right hands.

Not strange at all my friend. You move the clamping device to the right side when you tilt the machine to the left. that way it wiil hold the matirial and will not get in the way of the cutting machine. 🤷🏻

Thanks for this video...very helpful as I'm interested in this model. On a side note....regarding timestamp 1:23....bless you brother...probably single for a while eh?

I tell you just one thing: “you get what you pay for”. This saw is very good, but it all depends what you’re gonna use it for.

jua tu ingles mola habla en español mejor