09-14 Acura TSX EPS control module | 32-09 | DIY | EPS | Please check power steering system
13,346
Published 2023-02-12
A regular cheap code scanner will not work, it needs to be a scanner that has SAS built in.
Part can be order for a hefty price of over $1k
Or go to a local junk yard and pull one out for under $30.
Warning:
“Please check power steering system”
Part # 39980-TL2-A0
Showa HTL2X-50-11M
_________________________________
Calibration Procedure:
Steering wheel calibration is a must, and easy to do,
First jack the front up on jack stand evenly
Then turn the key to on position
Turn the steering wheel left and position it at 10 degree
Turn the steering wheel right and position it at 10 degree
Put steering wheel back in the center, straight
the wheel.
Turn key off
Start the car, and it should be done.
__________________________________
Disclaimer:
“Sokhom Garage” Will take no responsibility for any damages, injuries, losses or liabilities associated with performance on your vehicles or others property, you do this at your own risk, my video is for guidance, and educational/informational purposes. As always be safe and wear ppe (personal protection equipment)
#DIY #acura #tsx #electric #replacement #specialedition #2ndgeneration #eps #module #unit #honda #TL
All Comments (14)
-
My 2013 TSX EPS unit is being replaced under warranty. They extended the warranty on EPS units to 15 years, unlimited mileage on some cars/years. Check on line, or at the Acura Dealership. If you already did the repairs, you might can get your money back (I read that on line).
-
Hello bruvva I just repaired my EPS today thanks to this video. I cannot thank you enough for making this available to everyone. I have saved alot of money going to a mechanic who would have probs ripped me off.
-
Hi Guys..! Just spent an hour or so stripping this apart to take my EPS module out. Had the dreaded EPS warning light and bing and no power steering.. ordered a replacement off ebay. Just keepin my fingers x'd it fixes my EPS problem. Thanks guys your how to video helped alot.. 😊
-
Thankful for this video .
-
Cut the bottom glove box trim that's perforated and made to be cut. Pull blower box. Makes job twice as easy. Thanks for video though.
-
👍👍👍👌👌👌👌💯💯
-
Thank you!!
-
hey man, at 2:27 on top of the fuse box, there is slider type clip, I have 2.connectors on that blocking the screw. did you had those. If yes, how did you remove them
-
Do you know if this part can only go bad when it rains? I know that sounds funny, but I have a 2010 Acura TL, when it rains the power steering goes out, after it stops raining, everything is fine..Thoughts?
-
I installed the used module; got exact same code. It’s definitely the wiring but I don’t know where to look for connections Beyond inside directly connected to module and those all look fine. Where would the next connector Be located so I can check? My fault code is 33-1 low fet stuck on.
-
Did you do the toque sensor neutral position memorization after installing? The sensor needs to be calibrated now
-
Anyone know if TL model is similar install process to this one? Can’t find much info on it
-
Mine went out after driving thru deep rain water one night
