Tech Basics - How to thread a rod

Thank you for a clear and simple video. After watching it I reground the taper at the end of the shaft and that finally allowed me to get the die started. Very satisfying feeling when it’s all done.

Perfect demonstration! thank you for the learning experience

Thanks man I’m going to do this to my coilover I bout a new set and using my impact I snapped the damn thing now I need to rethread thank you

Good content. Thanks for uploading

Very helpful and clear. Thanks for sharing

helpful hints, good sir

Thank you. exactly what I was looking for. Does this technic work for a tube/pipe?

@IMAT - This informative video is getting on the older side, so I don't know if you monitor it these days, but I've got a question about threading pipe that I hope you can answer for me. I've got a project in mind that will require 1.5" threaded rod in 4-foot lengths. As you can imagine, it's extremely expensive to buy this type of threaded rod, so my question is whether or not it is possible to use a ratcheting pipe threader to cut usable thread along the entire length of a 4-foot section of steel pipe? The ideal being to use less-expensive Sch 80 steel pipe to create an alternative to 1.5" steel threaded rod. Thank you for any help.

Would this work on a keyed shaft?

No adjustment on the die set screw for depth of cut?

Where to get the DIY and how you determine the sizes?

Good video

Good👍👍

How do you ensure it starts straight, and not crooked, without a guide?

What was the actual size of the precut rod?

Cool

How do you measure rod size and match die to rod?

Is it a harder job to do it to stainless?

how to stop rod from spinning in the vice. some reason a new tap albeit from China seems to grab the rod

Good