2011 Mercedes E350 no crank/ no start.
5,369
Published 2023-12-23
There was water in the driver's floor board and we discovered a huge problem that needs addressed. More follow up checks will be needed but we likely won't be seeing this car again.
All Comments (5)
-
That 'Thingy whatjumacallit' 🙂 is a 'Power distributor connector, like a roundabout or an intersection main Gateway, all communications come and go from there through the Can Low and can hi, there are 2 Parallel 60 Ohm resistors in that block assembly so if 1 Can system gets shorted or open circuit and you measure with an Ohmmeter you will read 120 Ohms, it should only read 60 Ohms if the integrity of the circuit is good.
-
Hi please help my car wont crank and it wont go out of park the scanner picked this up... CAN communication (no communication with electronic gear selector) CAN communication ( no communication with body control module) CAN communication (no connections with esl) Any advice would be appreciated
-
Xheck your duel relat switch!
-
What's the point of this video? Another 3 minutes I'll never get back. Thanks!